Window Contact Integration - Button Usage Example - ABB i-bus KNX Product Manual

®

i-bus KNX
c. Select the number of telegrams the EnOcean light actuator needs to be Teach-in.
Check your EnOcean device manual for more information.
d. Set the EnOcean device you want to use in learning mode.
e. Press the Accept button. The selected number of telegrams in the dropdown
menu will be sent to the EnOcean device.
5. Close the plugin (all changes will be saved).
6. Use ETS to setup proper KNX group addresses for each communication object and also
proper KNX physical address for KNX/EnOcean Gateway.
7. Download current KNX configuration to the gateway as with any other KNX product.
8. The EnOcean device (the light actuator in this case) and the KNX/EnOcean Gateway
are linked and ready to be used together with the KNX installation.
Figure 3.4 KNX/EnOcean Gateway and Window Contact integration example
In order to see an example, we are going to proceed with the integration of an EnOcean
Window contact. In this case, chipID information is set up using the gateway buttons and not the
plugin.
1. Connect KNX/EnOcean Gateway to the KNX bus and check EnOcean devices location.
2. Open the KNX/EnOcean Gateway plugin in the ETS and click on the Add Device Node
button.
ABB STOTZ-KONTAKT GmbH
Eppelheimer Straße 82, 69123 Heidelberg, Germany
 +49 (0) 6221 701 607
 +49 (0) 6221 701 724
EG/A 32.2.1
Figure 3.3 Teach-in process for rocker with multiple teach-in telegrams
KNX/EnOcean Gateway
www.abb.com/knx
Technische Helpline / Technical Support
 +49 (0) 6221 701 434 E-Mail: knx.helpline@de.abb.com
User's manual r1.5 eng
9 / 47