Setting Of Parameter For Which An Item Should Be Selected - Toshiba TOSVERT VF-AS3 Instruction Manual

■ Setting of parameter for which an item should be selected

For an example, here is a procedure to set an extended parameter <F710: Standard mode display>.
1 Press the [ESC] key to change from [Standard
mode] to [Setting mode].
In the example on the right, the operation panel is
in [Standard mode], and the output frequency is
displayed in the middle of the screen.
• To switch from [Monitor mode], press the [F3] key
("Setting").
• Switch from [Easy mode] to [Standard mode] or
[Monitor mode]. For details of switching of
display modes, refer to [3. 1. 2].
The [Setting mode] screen is displayed.
• If [Setting mode] is not displayed on the screen even after the above operation, check the
Memo
<PSEL: Parameter mode select> setting. When "2: Easy mode only" is set, change the setting.
For details, refer to [5. 1. 8].
2 Select "5. Extended parameter (F---)" with the
touch wheel.
The selected item is highlighted.
3 Press the [OK] key.
The extended parameter screen is displayed. The
screen showing the list of each category with 100
parameters is displayed.
Easy
1. History function
2. Direct access
3. Guidance function
4. Basic parameters
5. Extended parameters(F - - -)
Top
1. History function
2. Direct access
3. Guidance function
4. Basic parameters
5. Extended parameters(F - - -)
Top
Extended parameters (F ---)
Input/output parameters (F1 - -)
3.1
Frequency parameters (F2 - -)
3.2
Operation parameters (F3 - -)
3.3
Motor parameters 1 (F4 - -)
3.4
Acc/dec parameters (F5 - -)
3.5
Top
4-15
4. [Basic operation] Operation methods of motor
E6582062
STOP 0.0Hz
14:47
Standard Mode
0.0
Hz
Screen Copy Monitor
STOP 0.0Hz
14:00
Setting Mode
Monitor
STOP 0.0Hz
15:07
Setting Mode
Monitor
STOP 0.0Hz
14:36
0
Monitor
3
4
9