Setting Torque Command Value In Panel Run - Toshiba TOSVERT VF-AS3 Instruction Manual

6. 34. 10 Setting torque command value in panel run

<F725: Panel torque command>
■ Function
This parameter is used to set a torque command value when torque control is performed in panel
run.
■ Parameter setting
Title Parameter name
F725 Panel torque command
■ Guideline for the setting
<F725: Panel torque command> is enabled only when <F420: Torque command select> is "12" and
acts as command value(%).
For details, refer to torque control.
• How to operate the operation panel -> Refer to [3. 1. 1].
• How to switch display mode on the operation panel -> Refer to [3. 1. 2].
Reference
• Procedure to change parameter setting -> Refer to [4. 2. 3]
• Details on operation by external signals -> Refer to [Chapter 7].
F725 : Panel torque command
Min: -250
X1000
Adjustment range
-250 to +250
6-175
E6582062
STOP 0.0Hz
14:15
+0
%
Max: 250
X100 X10 X1
Unit Default setting
% 0
6. [Advanced] How to use parameters
3
4
6
9