ABB ACS800 Hardware Manual page 111

5. Close the cabinet doors.
6. Switch on the auxiliary control voltage of the drive.
7. Switch the panel from the inverter unit to the DSU. The supply and inverter units
are connected to the same panel through a panel link. The panel communicates
with either one at the time. The switching between the nodes online is instructed
in chapter Control panel in the Firmware manual of the drive application
program.
8. Make the necessary parameter adjustments in the drive firmware. Refer to the
appropriate Firmware manual of the drive application program.
9. Set the number of the existing supply modules and activate the Reduced run
function with parameter 16.10 INT CONFIG USER. For more information, refer
to ACS800 diode supply control program firmware manual
(3AUA0000068937[English]).
111
Maintenance