Installation And Commissioning Flowchart - ABB ACS800 Hardware Manual

Installation and commissioning flowchart

Plan the installation.
Check the ambient conditions, ratings, required
cooling air flow, input power connection, compatibility
of the motor, motor connection, and other technical
data.
Select the cables.
Unpack and check the units. Check the number of
DSUs.
Check the type designation indicated by the type
designation label with the original order. If the drive is
about to be connected to an IT (ungrounded) system,
check that the drive is not equipped with EMC/RFI
filtering (option +E202). Check that all necessary
optional modules and equipment are present and
correct.
Only intact units may be started up.
Check the installation site.
Route the cables.
Mount the cabinet line-up.
Check the insulation of the motor and the motor
cable.
Connect the power cables. Connect the control and
the auxiliary control cables.
Check the installation.
Commission the drive.
Commission the optional brake chopper (if present).
Task See
Technical data
Planning the electrical installation
Option manuals (if optional equipment is
included)
Mechanical installation
Hardware description
For instructions on how to disconnect the EMC/
RFI filtering, contact your local ABB
representative.
If the converter has been non-operational for
more than one year, the converter DC link
capacitors need to be reformed. Contact your
local ABB representative for more information.
Mechanical installation, Technical data
Planning the electrical installation: Routing the
cables
Mechanical installation
Electrical installation: Checking the insulation of
the assembly
Mechanical installation, Planning the electrical
installation, Electrical installation, Resistor
braking (optional)
Installation checklist and start-up
Installation checklist and start-up
Resistor braking
21
About this manual