Start Auto Adjust Function; Switching The Operating Mode; Switching To The Configuration Level (Parameterization) - ABB PositionMaster EDP300 Operating Instruction

8.2.3

Start Auto Adjust function

The Auto Adjust function can be configured and started in the
"Operating Mode" menu.
Process display
1. Use to switch to the Operating Mode menu.
Operating Mode
Auto Adjust
O Adaptive
O Control
O Manual SP
O Manual Sensor
Configuration
Back
2. Use or to select the "Auto Adjust" operating
mode.
3. Use to confirm your selection. Press and hold down
the control button for at least 4 seconds (wait for the time
to count down on the top left of the display).
Auto Adjust
Full Auto Adjust
Rotary
Linear
Exit
1. Use or to select the "Actuator type".
Select "Rotary" for part-turn (rotary) actuators,
"Linear" for linear actuators.
IMPORTANT (NOTE)
"Auto Adjust Mode" can be set by default at
configuration level under "Easy Setup -> Auto
Adjust Mode".
Auto Adjust
Full Auto Adjust
Exhaust
Abort
The progress of the Auto Adjust function is shown in a bar
graph. The function can be terminated with "Abort" if
necessary. Once Auto Adjust has been completed
successfully, "Auto Adjust Complete" is displayed. The device
then switches to the process display automatically.
OK
8.2.4

Switching the operating mode

The operating mode is displayed and changed in the operating
modes menu.
Additionally, it is possible to switch to the configuration level
from there.
Process display
1. Use to switch to the operating modes menu.
Operating Mode
Auto Adjust
O Adaptive
O Control
O Manual SP
O Manual Sensor
Configuration
Back
2. Use or to select the required operating mode.
3. Use to confirm your selection.
8.2.5 Switching to the configuration level
(parameterization)
The device parameters can be displayed and changed on the
configuration level.
Operating Mode
Auto Adjust
O Adaptive
O Control
O Manual SP
O Manual Sensor
Configuration
Back
4. Use or to select the "Configuration" operating
mode.
5. Use to confirm your selection.
OK
OK
PositionMaster EDP300 | OI/EDP300-EN 27