Selecting And Changing Parameters - ABB PositionMaster EDP300 Operating Instruction

8.2.6

Selecting and changing parameters

Entry from table
When an entry is made from a table, a value is selected from a
list of parameter values.
Menu Name
Parameter Name
Actual Value
Next
1. Select the parameters you want to set in the menu.
2. Use to call up the list of available parameter values.
The parameter value that is currently set is highlighted.
Parameter Name
Parameter 1
Parameter 2
Parameter 3
Cancel
3. Use or to select the required value.
4. Use to confirm your selection.
This concludes the procedure for selecting a parameter value.
28 OI/EDP300-EN | PositionMaster EDP300
Edit
OK
Numerical entry
When a numerical entry is made, a value is set by entering the
individual decimal positions.
Menu Name
Parameter Name
12.3456 [Unit]
Next
1. Select the parameters you want to set in the menu.
2. Use to call up the parameter for editing. The position
that is currently selected is highlighted.
Parameter Name
12.3456 [Unit]
Next
3. Use to select the decimal position to be changed.
4. Use or to set the required value.
5. Use to select the next decimal position.
6. If necessary, select and set other decimal positions using
the same procedure as described in steps 3 and 4.
7. Use to confirm your settings.
This concludes the procedure for changing a parameter value.
Edit
OK