3.2.2
How to set the frequency
[Example of fmod setting procedure] fmod=1: Setting the frequency by the terminal VIA
Panel operation
LED display
00
MODE
auh
fmod
1fmod
*
Pressing the MODE key twice returns the display to standard monitor mode (displaying output frequency).
(1) Setting using the keypad or extension panel option (fmod=0 or 3)
: Moves the frequency up
For an extension panel option,
Example of operating from the panel (=: press in center to save)
Panel operation
LED display
Example of operating from the panel (=: save even if power is off)
Panel operation
LED display
-
(2) Setting of frequency using external signals to terminal block (=, or )
Refer to section 7.3 for details.
(3) Switching two frequency commands Refer to section 5.8 for details.
Displays the output frequency (operation stopped).
(When standard monitor display selection f710=0 [output frequency])
Displays the first basic parameter [History (auh)].
Turn the setting dial, and select "fmod".
Press the center of the setting dial to read the parameter value.
0
(Standard default: 0).
Turn the setting dial to change the parameter value to (terminal block
1
VIA).
The parameter value is written. fmod and the parameter value are
displayed alternately several times.
: Moves the frequency down
key moves the frequency up,
Displays the output frequency.
(When standard monitor display selection = [output frequency])
Set the frequency command value. (The frequency will not be saved
if the power is turned off in this state.)
Save the frequency command value. and the frequency are
displayed alternately.
Display the output frequency.
(When standard monitor display selection is set as =
[output frequency])
Set the frequency command value.
The frequency will be saved when the power is turned off in this
state.
C-7
Operation
key moves the frequency down.
Operation
Operation
E6582175
3