Mpls Te Configuration Task List; Configuring Basic Mpls Te - HP 10500 SERIES Configuration Manual

RFC 3209, RSVP-TE: Extensions to RSVP for LSP Tunnels
•
RFC 2961, RSVP Refresh Overhead Reduction Extensions
•
• RFC 3564, Requirements for Support of Differentiated Service-aware MPLS Traffic Engineering
ITU-T Recommendation Y.1720, Protection switching for MPLS networks
•

MPLS TE configuration task list

Task

Configuring basic MPLS TE

Configuring an
MPLS TE tunnel
Configuring RSVP-TE advanced features
Tuning CR-LSP setup
Tuning MPLS TE tunnel setup
Configuring traffic forwarding
Configuring traffic forwarding tuning parameters
Configuring CR-LSP backup
Configuring FRR
Inspecting an MPLS TE tunnel
Configuring protection switching
Configuring basic MPLS TE
Perform this task to perform the basic MPLS TE settings required for all MPLS TE features.
Before you configure the basic MPLS TE, complete the following tasks:
Configure static routing or IGPs to make sure all LSRs are reachable.
•
Configure basic MPLS.
•
For information about basic MPLS configurations, see
To configure basic MPLS TE:
Step
1. Enter system view.
2. Enter MPLS view.
3. Enable global MPLS TE.
4. Return to system view.
Creating an MPLS TE tunnel over a static CR-LSP
Configuring an MPLS TE tunnel with a dynamic signaling protocol
Command
system-view
mpls
mpls te
quit
Forwarding traffic along MPLS TE
tunnels using static routes
Forwarding traffic along MPLS TE
tunnels through automatic route
advertisement
"Configuring basic
101
Remarks
Required.
Required.
Use either approach.
Optional.
Optional.
Optional.
Required.
Use either approach.
Optional.
Optional.
Optional.
Optional.
Optional.
MPLS."
Remarks
N/A
N/A
Disabled by default.
N/A