HP 10500 SERIES Configuration Manual page 161

Class Type
Reserved BW
Setup Priority
Affinity Prop/Mask
Explicit Path Name
Tie-Breaking Policy :
Metric Type
Record Route
FRR Flag
BackUpBW Type
Route Pinning
Retry Limit
Reopt
Back Up Type
Back Up LSPID
Auto BW
Min BW
Current Collected BW:
Interfaces Protected:
VPN Bind Type
VPN Bind Value
Car Policy
Tunnel Group
Primary Tunnel
Backup Tunnel
Group Status
If you perform the display mpls te tunnel-interface command immediately after an FRR protection
switch, you are likely to see two CR-LSPs in up state are present. This is normal because the
make-before-break mechanism of FRR introduces a delay before removing the old LSP after a new
LSP is created.
# Execute the display mpls lsp verbose command on Switch B.
[SwitchB] display mpls lsp verbose
------------------------------------------------------------------
LSP Information: RSVP LSP
------------------------------------------------------------------
No
IngressLsrID
LocalLspID
Tunnel-Interface
Fec
Nexthop
In-Label
Out-Label
In-Interface
Out-Interface
LspIndex
Tunnel ID
LsrType
: CT0
: 0 kbps
: 7
: 0x0/0x0
: pri-path
None
: None
: Enabled Record Label :
: Enabled BackUpBW Flag:
: - BackUpBW
: Disabled
: 10
: Disabled
: None
: -
: Disabled
: -
-
-
: NONE
: -
: Disabled
: Primary
: -
: -
: -
: 1
: 1.1.1.1
: 1
: Tunnel4
: 4.4.4.4/32
: 3.1.1.2
: 1024
: 1024
: Vlan-interface1
: Vlan-interface2
: 4097
: 0x22001
: Transit
153
Tunnel BW : 0 kbps
Hold Priority: 7
Enabled
Not Supported
: -
Retry Interval:
Reopt Freq :
Auto BW Freq :
Max BW :
10 sec
-
-
-