HP 10500 SERIES Configuration Manual page 24

Configuring static routing between MCE and PE
Step
1. Enter system view.
2. Configure a static route
for a VPN instance.
3. Configure the default
precedence for static
routes.
Configuring RIP between MCE and PE
Step
1. Enter system view.
2. Create a RIP process for a
VPN instance and enter RIP
view.
3. Enable RIP on the interface
attached to the specified
network.
4. Redistribute the VPN routes.
5. Configure the default cost
value for the redistributed
routes.
Configuring OSPF between MCE and PE
Step
1. Enter system view.
2. Create an OSPF process
for a VPN instance and
enter OSPF view.
Command
system-view
•
ip route-static dest-address { mask | mask-length }
{ gateway-address | interface-type interface-number
[ gateway-address ] | vpn-instance
d-vpn-instance-name gateway-address } [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
•
ip route-static vpn-instance
s-vpn-instance-name&<1-6> dest-address { mask |
mask-length } { gateway-address [ public ] |
interface-type interface-number [ gateway-address ] |
vpn-instance d-vpn-instance-name gateway-address }
[ preference preference-value ] [ tag tag-value ]
[ description description-text ]
ip route-static default-preference default-preference-value
Command
system-view
rip [ process-id ] vpn-instance
vpn-instance-name
network network-address
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost | route-policy
route-policy-name | tag tag ] *
default cost value
Command
system-view
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
16
Remarks
N/A
Use either
command.
Optional.
60 by default.
Remarks
N/A
N/A
By default, RIP is disabled on
an interface.
By default, no route of any
other routing protocol is
redistributed into RIP.
Optional.
0 by default.
Remarks
N/A
N/A