HP 10500 SERIES Configuration Manual page 35

Figure 7 Network diagram
Configuration procedure
Create VPN instances on the MCE and PE 1, and bind the VPN instances with VLAN interfaces in
1.
the same way as that described in
shown.)
Configure routing between the MCE and VPN sites:
2.
# Start an OSPF process on the devices in the two VPNs and advertise the subnets. (Details not
shown.)
# Configure OSPF on the MCE, and bind OSPF process 10 with VPN instance vpn1 to learn the
routes of VPN 1.
<MCE> system-view
[MCE] ospf router-id 10.214.10.3 10 vpn-instance vpn1
[MCE-ospf-10] area 0
[MCE-ospf-10-area-0.0.0.0] network 10.214.10.0 0.0.0.255
# Display the routing table of VPN 1 on the MCE.
[MCE-ospf-10-area-0.0.0.0] display ip routing-table vpn-instance vpn1
Routing Tables: vpn1
Destination/Mask
10.214.10.0/24
10.214.10.3/32
127.0.0.0/8
Destinations : 5
Proto Pre
Direct 0
Direct 0
Direct 0
"Using OSPF to advertise VPN routes to the
Routes : 5
Cost NextHop
0 10.214.10.3
0 127.0.0.1
0 127.0.0.1
27
PE." (Details not
Interface
Vlan10
InLoop0
InLoop0