HP 10500 SERIES Configuration Manual page 49

Step
5. Redistribute remote site routes
advertised by the PE.
6. Return to system view.
7. Enter interface view.
8. Enable the IPv6 IS-IS process
on the interface.
Configuring EBGP between IPv6 MCE and VPN site
To use EBGP for exchanging routing information between an IPv6 MCE and IPv6 VPN sites, you must
configure a BGP peer for each IPv6 VPN instance on the IPv6 MCE, and redistribute the IGP routes of
each VPN instance on the IPv6 VPN sites.
If EBGP is used for route exchange, you also can configure filtering policies to filter the received routes
and the routes to be advertised.
Configure the IPv6 MCE:
1.
Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 BGP-VPN instance
view.
4. Specify an IPv6 BGP peer in
an AS.
5. Redistribute remote site routes
advertised by the PE.
6. Configure filtering of
redistributed routes.
7. Configure a filtering policy to
filter the received routes.
NOTE:
After you configure an IPv6 BGP VPN instance, the IPv6 BGP route exchange for the IPv6 VPN instance is
the same as the normal IPv6 BGP VPN route exchange. For more information about IPv6 BGP, see
3—IP Routing Configuration Guide
Command
ipv6 import-route protocol
[ process-id ] [ allow-ibgp ] [ cost
cost | [ level-1 | level-1-2 |
level-2 ] | route-policy
route-policy-name | tag tag ] *
quit
interface interface-type
interface-number
isis ipv6 enable [ process-id ]
Command
system-view
bgp as-number
ipv6-family vpn-instance
vpn-instance-name
peer ipv6-address as-number
as-number
import-route protocol [ process-id
[ med med-value | route-policy
route-policy-name ] * ]
filter-policy { acl6-number |
ipv6-prefix ip-prefix-name } export
[ direct | isisv6 process-id | ripng
process-id | static ]
filter-policy { acl6-number |
ipv6-prefix ip-prefix-name } import
.
Remarks
Optional.
By default, no routes from any
other routing protocol are
redistributed to IPv6 IS-IS.
If you do not specify the route level
in the command, redistributed
routes are added to the level-2
routing table by default.
N/A
N/A
Disabled by default.
Remarks
N/A
N/A
N/A
N/A
By default, No route redistribution
is configured.
Optional.
By default, the IPv6 MCE does not
filter redistributed routes.
Optional.
By default, the IPv6 MCE does not
filter the received routes.
Layer