Configuring Basic Mpls L2Vpn; Configuring A Pe-Ce Interface; Configuring Ethernet Encapsulation - HP 10500 SERIES Configuration Manual

Task

Configuring basic MPLS L2VPN

Configuring a PE-CE interface

Configuring CCC MPLS L2VPN
Configuring SVC MPLS L2VPN
Configuring Martini MPLS L2VPN
Configuring Kompella MPLS L2VPN
Configuring basic MPLS L2VPN
Step
1. Enter system view.
2. Configure the LSR ID.
Configure basic MPLS and
3.
enter MPLS view.
4. Return to system view.
5. Enable L2VPN and enter
L2VPN view.
6. Enable MPLS L2VPN.
Configuring a PE-CE interface
A PE-CE interface refers to the PE's interface connected to a CE.
As shown in
Table 2 Encapsulation types on a PE-CE interface of a PE
Encapsulation type
Ethernet
VLAN

Configuring Ethernet encapsulation

Martini MPLS L2VPN configuration for a service instance allows you to configure an encapsulation type
for a PE-CE interface while other types of MPLS L2VPN require a PE-CE interface to use the default
encapsulation type.
Table 2, a PE-CE interface can use various types of encapsulations.
Remarks
Required.
Perform this task to enable MPLS L2VPN. You can
perform other MPLS L2VPN configurations only after
you enable MPLS L2VPN.
Required.
Perform this task to set up an AC between a PE and a
CE.
Use one of the approaches according to the MPLS
L2VPN implementation method.
Perform this task to set up a VC, and bind the VC to an
AC.
Command
system-view
mpls lsr-id lsr-id
mpls
quit
l2vpn
mpls l2vpn
Configuration
Configuring Ethernet encapsulation
Configuring VLAN encapsulation
199
Remarks
N/A
N/A
N/A
N/A
Disabled by default.
Disabled by default.