HP 10500 SERIES Configuration Manual page 375

After completing the configurations, issue the display bgp peer command or the display bgp
vpnv6 all peer command on the PEs. The output shows a BGP peer relationship has been
established between the PEs, and has reached Established state.
[PE1] display bgp peer
BGP local router ID : 1.1.1.9
Local AS number : 100
Total number of peers : 1
Peer
3.3.3.9
Verify the configuration:
6.
# Issue the display ipv6 routing-table vpn-instance command on the PEs. The output shows the
routes to the CEs. Take PE 1 as an example:
[PE1] display ipv6 routing-table vpn-instance vpn1
Routing Table :
Destinations : 3
Destination: 2001:1::/96
NextHop : 2001:1::2
Interface : Vlan11
Destination: 2001:1::2/128
NextHop : ::1
Interface : InLoop0
Destination: 2001:2::/96
NextHop : ::FFFF:303:309
Interface : NULL0
[PE1] display ipv6 routing-table vpn-instance vpn2
Routing Table :
Destinations : 3
Destination: 2001:3::/96
NextHop : 2001:3::2
Interface : Vlan12
Destination: 2001:3::2/128
NextHop : ::1
Interface : InLoop0
Destination: 2001:4::/96
NextHop : ::FFFF:303:309
Interface : NULL0
# From each CE, ping other CEs. CEs of the same VPN can ping each other. Those of different
VPNs cannot ping each other. For example, CE 1 can ping CE 3 (2001:3::1), but cannot ping CE
4 (2001:4::1):
[CE1] ping ipv6 2001:3::1
PING 2001:3::1 : 56
Reply from 2001:3::1
AS MsgRcvd MsgSent
100 2
Routes : 3
Routes : 3
data bytes, press CTRL_C to break
367
Peers in established state : 1
OutQ PrefRcv
6 0 0
Up/Down State
00:00:12 Established
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : BGP4+
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : BGP4+
Preference: 0
Cost : 0