Overview Of Programming - Panasonic KX-HDV130 Manual

1.
2.
[ ]/[ ]: "System Settings" →
3.
[ ]/[ ]: "Network Settings" →
4.
[ ]/[ ]: "IPv6 Settings" →
5.
[ ]/[ ]: "Static" →
6. Enter the IP address, Prefix (for IPv6), Default Gateway, DNS1 (primary DNS server), and, if necessary,
DNS2 (secondary DNS server), and then press
KX-HDV330/KX-HDV430
[In standby mode]
1.
Tap / → "System Settings"
2. Tap "Network Settings"
3.
Tap / → "IPv6 Settings"
4.
Tap / → "Connection Mode"
5.
Select "Static" → "OK"
6. Enter the IP address, subnet mask, default gateway, DNS1 (primary DNS server), and, if necessary,
DNS2 (secondary DNS server), and then tap "OK".
Note
•
If your phone system dealer/service provider does not allow you these settings, you cannot change
them even though the unit shows the setting menu. Contact your phone system dealer/service
provider for further information.
•
If you select DHCP for the connection mode, all the settings concerning static connection will be
ignored, even if they have been specified.
•
If you select DHCP for the connection mode and Auto for DNS, the DNS server settings (DNS1 and
DNS2) will be ignored, even if they have been specified.

1.1.4 Overview of Programming

There are 3 types of programming, as shown in the table below:
Programming
Type
Phone user
interface
programming
Web user
interface
programming
Document Version: 2017-07
OK
OK
OK
OK
Description
Configuring the unit's settings directly from the unit.
Configuring the unit's settings by accessing the Web
user interface from a PC connected to the same
network.
.
OK
1.1.4 Overview of Programming
References
→ 1.1.5 Phone User
Interface Programming
→ 3 Phone User Interface
Programming
→ 1.1.6 Web User Interface
Programming
→ 4 Web User Interface
Programming
Administrator Guide 15