Power Supply - GE 869 Instruction Manual

SPECIFICATIONS

Power Supply

Communications
1–30
POWER SUPPLY
Nominal DC Voltage: ......................................... 125 to 250 V
Minimum DC Voltage: ....................................... 88 V
Maximum DC Voltage:...................................... 300 V
Nominal AC Voltage:.......................................... 100 to 240 V at 50/60 Hz
Minimum AC Voltage:........................................ 88 V at 50 to 60 Hz
Maximum AC Voltage: ...................................... 265 V at 50 to 60 Hz
Voltage loss ride through:............................... 20 ms duration
POWER SUPPLY (FOR "L" DC ONLY OPTION)
Nominal DC Voltage: ......................................... 24 V to 48 V
Minimum DC Voltage: ....................................... 20 V
Maximum DC Voltage:...................................... 60 V
POWER CONSUMPTION
Typical: .................................................................... 20 W / 40 VA
Maximum: .............................................................. 34 W / 70 VA
ETHERNET – BASE OFFERING
Modes: ..................................................................... 10/100 Mbps
One Port:................................................................. RJ45
Protocol:.................................................................. Modbus TCP
ETHERNET – CARD OPTION "C" - 2X COPPER (RJ45) PORTS
Modes: ..................................................................... 10/100 MB
Two Ports:............................................................... RJ45 (with this option both enabled ports are on the
Protocols:................................................................ Modbus TCP, DNP3.0, IEC60870-5-104, IEC 61850, IEC 61850
ETHERNET – CARD OPTION "S" - 2X ST FIBER PORTS
Modes: ..................................................................... 100 MB
Two Ports:............................................................... ST (with this option both enabled ports are on the
Protocols:................................................................ Modbus TCP, DNP3.0, IEC60870-5-104, IEC 61850, IEC 61850
Wavelength:.......................................................... 1310nm
Typical link distance:......................................... 4 km
USB
Standard specification:.................................... Compliant with USB 2.0
Protocols:................................................................ Modbus TCP, TFTP
SERIAL
RS485 port: ............................................................ Isolated
Baud rates: ............................................................ Supports 9600, 19200, 38400, 57600, and 115200 kbps
Response time: .................................................... 10 ms typical
Parity: ....................................................................... None, Odd, Even
Protocol:.................................................................. Modbus RTU, DNP 3.0, IEC 60870-5-103
Maximum distance: ........................................... 1200 m (4000 feet)
Isolation: ................................................................. 2 kV
WIFI
Standard specification:.................................... IEEE802.11bgn
Range:...................................................................... 30 ft (direct line of sight)
communications card; the Ethernet port located on the base
CPU is disabled)
GOOSE, IEEE 1588, SNTP, IEC 62439-3 clause 4 (PRP)
communications card; the Ethernet port located on the base
CPU is disabled)
GOOSE, IEEE 1588, SNTP, IEC 62439-3 clause 4 (PRP)
869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 1: INTRODUCTION