GE 869 Instruction Manual page 140

DEVICE
..\Current\Phase TOC 1
Item Name
Function
Signal Input
Input
Pickup
Curve
TDM
Reset
Direction
Voltage Restraint
Volt Lower Limit
Block
Relays
Events
Targets
PTOC 1
..\Setpoints\Inputs
Item Name
Contact Inputs
Virtual Inputs
Analog Inputs
Remote Inputs
Inputs V Inputs
4–8
Figure 4-4: Comparing the setpoints for Regular and Simplified mode
r
Value Unit
Disabled
CT Bank 1 -J1
Phasor
1.000 x CT
IEEE Mod Inverse
1.00
Instantaneous
Disabled
Disabled
0.1 p.u.
Off
Do Not Operate
Enabled
Self-Reset
Example 2: More about the Function/Feature view control
The differences in the Input setpoints screens for Regular and Simplified mode are shown
below. Under Simplified mode, the Virtual Inputs and Remote Inputs are hidden for any
configuration change. However, the device will still accept and process virtual and remote
inputs based on what is configured during Regular mode. This way, Simplified
configuration mode does not change the behavior of the device.
Figure 4-5: Comparing the Inputs screens for Regular and Simplified mode
r
MA In Rem In
Path:
Setpoints > Device > Config Mode
CONFIG MODE
Range: Simplified, Regular
Default: Regular
This setting allows selection of the configuration mode while the device is accessed by
the "Administrator" role. In Regular configuration mode, all values in settings/functions
can be edited. In Simplified configuration mode, selected settings/functions are hidden
or the values are read-only to enhance User eXperience (UX) with minimum setpoint
changes.
Simplified
..\Current\Phase TOC 1
Item Name
Function
Signal Input
Pickup
Curve
TDM
Reset
Direction
Voltage Restraint
Relays
PTOC 1
Simplified
..\Setpoints\Inputs
Item Name
Contact Inputs
Analog Inputs
Inputs MA In
869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: SETPOINTS
Value Unit
Disabled
CT Bank 1 -J1
1.000 x CT
IEEE Mod Inverse
1.00
Instantaneous
Disabled
Disabled
Do Not Operate