GE 869 Instruction Manual page 85

CHAPTER 3: INTERFACES
869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
The Breaker/Contactor and motor status color is based on the following logic.
Figure 3-8: Breaker/Contactor and Motor status color
SLD Breaker/Contactor symbol Color
Color Scheme Open Color Close Color
Red (Open)
Green (Open)
Regardless of the switching device selection (
the breaker/contactor colors will follow the color scheme setting (
Front Panel > Display Properties > Color Scheme
selected.
The parameters displayed in the Front panel screen example are as follows:
Parameter
Ia
Ib
Ic
Ig
Ep
Eq
P
Q
PF
FRONT CONTROL PANEL INTERFACE
Not
Unknown Disconnected Stopped Starting Running Overload Tripped
Configured
System > Motor > Setup > Switching Device
). By default, the "Green (Open)" setting is
Input for the value
Metering\CT Bank 1 -J1\J1 Ia
Metering\CT Bank 1 -J1\J1 Ib
Metering\CT Bank 1 -J1\J1 Ic
Metering\CT Bank 1 -J1\J1 Ig
Metering\Energy 1\Pwr1 Pos WattHours
Metering\Energy 1\Pwr1 Pos VarHours
Metering\Power 1\Pwr1 Real
Metering\Power 1\Pwr1 Reactive
Metering\Power 1\Pwr1 PF
Motor Status
Red Green Green Red Orange
Green Red Red Green Orange
Setpoints > Device >
),
3–7