HP 830 Command Reference Manual page 10

Table 1 Command output
Field
GigabitEthernet1/0/1 current state
IP Packet Frame Type
Loopback
1000Mbps-speed mode
full-duplex mode
Link speed type is autonegotiation
link duplex type is autonegotiation
The Maximum Frame Length
Broadcast MAX-ratio
Unicast MAX-ratio
Multicast MAX-ratio
Allow jumbo frame to pass
PVID
Port link-type
Tagged VLAN ID
Untagged VLAN ID
Last clearing of counters: Never
Last 300 seconds input: 0
packets/sec 0 bytes/sec
Last 300 seconds output: 0
packets/sec 0 bytes/sec
Description
Physical state of the Ethernet interface. For more information, see
2.
Ethernet framing format on the interface.
Loopback testing status of the interface.
The interface is operating at 1000 Mbps.
This field displays Unknown-speed mode when the interface is
disconnected from the peer with which it will automatically negotiate a
port speed.
The interface is operating in full-duplex mode.
This field displays link duplex type is force link when the duplex mode
of the interface is fixed and not configurable.
The interface will negotiate a speed with its peer.
The interface will negotiate a duplex mode with its peer.
Maximum Ethernet frame length allowed on the interface.
Broadcast suppression threshold as a percentage of the maximum
interface rate. When the threshold is exceeded, the interface drops
broadcast packets.
Unknown unicast suppression threshold as a percentage of the
maximum interface rate. When the threshold is exceeded, the
interface drops unknown unicast packets.
Multicast suppression threshold as a percentage of the maximum
interface rate. When the threshold is exceeded, the interface drops
multicast packets.
Jumbo frames are allowed to pass through the interface.
Port VLAN ID.
Link type of the interface:
•
access.
•
trunk.
•
hybrid.
VLANs for which the interface sends packets without removing VLAN
tags.
VLANs for which the interface sends packets after removing VLAN
tags.
Time when the reset counters interface command was last used to clear
statistics on the interface. Never indicates that the reset counters
interface command was never used since the device was started.
Average rate of input and output traffic in the last 300 seconds, in pps
and Bps.
5
Table