Port - HP 830 Command Reference Manual

XGE1/0/1
XGE1/0/2
# Display information about the trunk ports.
<Sysname> display port trunk
Interface
BAGG1
XGE1/0/1
XGE1/0/2
Table 9 Command output
Field
Interface
PVID
VLAN passing
Tagged
Untagged

port

Use port to assign the specified access ports to the VLAN.
Use undo port to remove the specified access ports from the VLAN.
Syntax
port interface-list
undo port interface-list
Default
All ports are in VLAN 1. All ports are access ports. However, you can manually configure the port type.
For more information, see
Views
VLAN view
Default command level
2: System level
Parameters
interface-list: Specifies a space-separated list of up to 10 interface items. Each item specifies an interface
or a range of interfaces in the form of interface-type interface-number 1 to interface-type
interface-number 2. The value for interface-number 2 must be equal to or greater than the value for
interface-number 1.
Usage guidelines
This command is only applicable on access ports.
Untagged:1,
1 Tagged:
Untagged:1,
1 Tagged:
Untagged:1,
PVID VLAN passing
1 1,
1 1,
1 1,
Description
Port name.
Port VLAN ID.
VLANs for which the port allows packets to pass through.
VLANs for which the port sends packets without removing VLAN tags.
VLANs for which the port sends packets after removing VLAN tags.
"port link-type."
45
none
none