PPPoE server commands
Support for the commands in this chapter depends on the device model. For more information, see About
the Command References for HP Unified Wired-WLAN Products.
display pppoe-server session
Use display pppoe-server session to display information about PPPoE sessions on a device operating as
a PPPoE server.
Syntax
display pppoe-server session all [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
all: Displays all the information about PPPoE sessions.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Examples
# Display all the information about PPPoE sessions. (Assume the current device is operating as a PPPoE
server.)
<Sysname> display pppoe-server session all
Total PPPoE Session(s): 2
SID
Intf
1
Virtual-Template1:0
2
Virtual-Template2:0
Table 21 Command output
Field
SID
Intf
State
State OIntf
UP
Vlan2
UP
Vlan2
Description
PPPoE session ID.
Virtual-template interface.
PPPoE session state.
91
RemMAC
LocMAC
00e015004100 00e014004300
00e016004100 00e015004300