5. Remove the screw that secures the power button to the front bezel. Then, remove the power button
from the front bezel.
Figure 13. Removing the power button
6. Position the new power button so that the screw hole in the power button is aligned with the
corresponding hole in the front bezel. Then install the screw to secure the power button to the front bezel.
Figure 14. Installing the power button
7. Connect the power button cable to the power button connector on the system board. See "Parts on the
system board" on page 34.
8. Reinstall the front bezel. See "Front bezel" on page 97.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 174.
98
ThinkStation P410 Hardware Maintenance Manual