Cover Presence Switch - Lenovo ThinkStation P410 Hardware Maintenance Manual

4. Install a new battery.
Figure 53. Installing a new battery
5. Reinstall the computer cover and connect the cables. See "Completing the parts replacement" on
page 174.
Note: When the computer is turned on for the first time after replacing the battery, an error message
might be displayed. This is normal after replacing the battery.
6. Turn on the computer and all attached devices.
7. Use the Setup Utility program to set the date, time, and any passwords. See "Using the Setup Utility
program" on page 63.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 174.

Cover presence switch

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the cover presence switch, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 95.
2. Locate the cover presence switch. See "Computer components" on page 31.
3. Disconnect the cover presence switch cable from the cover presence switch connector on the system
board. See "Parts on the system board" on page 34.
4. Remove the screw that secures the cover presence switch and remove the cover presence switch
from the chassis.
Figure 54. Removing the cover presence switch
.
Chapter 9 Installing or replacing hardware
121