Thermal Sensor - Lenovo ThinkStation P410 Hardware Maintenance Manual

8. To install the storage converter into the 3.5-inch storage drive bracket, flex the bracket and align pin
pin 2 , pin 3 , and pin
Figure 69. Installing the storage converter with the new solid-state drive into the storage drive bracket
9. Install the storage converter with the bracket into the storage drive bay. See "Primary hard disk drive" on
page 125 or "Secondary hard disk drive" on page 126.
10. Connect the signal cable and the power cable to the solid-state drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 174.

Thermal sensor

Attention: Before you replace any FRU, be sure to read and understand Chapter 1 "Read this first: Important
safety information" on page 1.
To replace the thermal sensor, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 95.
2. Remove the front bezel. See "Front bezel" on page 97.
3. Locate the thermal sensor. See "Major FRUs and CRUs" on page 31.
4. Disconnect the thermal sensor cable from the thermal sensor connector on the system board. See
"Parts on the system board" on page 34.
132
ThinkStation P410 Hardware Maintenance Manual
4 on the bracket with the corresponding holes in the storage converter.
1 ,