Lenovo ThinkStation P410 Hardware Maintenance Manual page 137

1. Install the solid-state drive into the storage converter shipped with the solid-state drive. Then install the
four screws to secure the solid-state drive to the storage converter.
Figure 64. Installing the solid-state drive into the storage converter
2. Remove the 3.5-inch storage drive bracket out of the chassis.
3. To install the storage converter into the 3.5-inch storage drive bracket, flex the bracket and align pin
2 3
pin , pin , and pin
Figure 65. Installing the storage converter together with the solid-state drive into the storage drive bracket
4. Install the storage converter with the bracket into the desired storage drive bay. See "Primary hard disk
drive" on page 125 or "Secondary hard disk drive" on page 126.
5. Connect the signal cable and the power cable to the solid-state drive.
4
on the bracket with the corresponding holes in the storage converter.
.
Chapter 9 Installing or replacing hardware
1
,
129