Lenovo ThinkStation P410 Hardware Maintenance Manual page 155

5. Place the eSATA connector or IEEE 1394 connector into the metal retainer. Then insert the eSATA
connector or IEEE 1394 connector into the corresponding slot in the flex module as shown.
Figure 91. Installing the eSATA connector or IEEE 1394 connector in the flex module
6. Position the flex module cover on the flex module. Ensure that the rail guides on the bottom of the
cover engage the rails on the flex module. Then, push the cover to the front of the flex module until
it snaps into position.
Figure 92. Reinstalling the flex module cover
7. Connect the eSATA connector or IEEE 1394 connector cable to the corresponding connector on the
system board. See "Parts on the system board" on page 34.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 174.
Card reader
To install or replace a card reader in the flex module, do the following:
1. Remove the flex module out of the chassis. See "Optical drive" on page 111.
.
Chapter 9 Installing or replacing hardware
147