Lsdb-Overflow-Limit - HP FlexNetwork 3600 v2 Series Command Reference Manual

Default level
2: System level
Parameters
maximum-interval: Maximum LSA generation interval in seconds, in the range of 1 to 60. The default
is 5 seconds.
initial-interval: Minimum LSA generation interval in milliseconds, in the range of 10 to 60000. The
default is 0.
incremental-interval: LSA generation incremental interval in milliseconds, in the range of 10 to 60000.
The default is 5000 milliseconds.
Description
Use lsa-generation-interval to configure the OSPF LSA generation interval.
Use undo lsa-generation-interval to restore the default.
By default, the maximum interval is 5 seconds, the minimum interval is 0 milliseconds, and the
incremental interval is 5000 milliseconds..
With this command configured, when network changes are not frequent, LSAs are generated at the
initial-interval. If network changes become frequent, LSA generation interval is incremented by a
specified value each time a generation happens, up to the maximum-interval.
Related commands: lsa-arrival-interval.
Examples
# Configure the maximum LSA generation interval as 2 seconds, minimum interval as 100
milliseconds and incremental interval as 100 milliseconds.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] lsa-generation-interval 2 100 100

lsdb-overflow-limit

Syntax
lsdb-overflow-limit number
undo lsdb-overflow-limit
View
OSPF view
Default level
2: System level
Parameters
number: Specifies the upper limit of external LSAs in the LSDB, in the range of 1 to 1000000.
Description
Use lsdb-overflow-limit to specify the upper limit of external LSAs in the LSDB.
Use undo lsdb-overflow-limit to restore the default.
External LSAs in the LSDB are not limited by default.
Examples
# Specify the upper limit of external LSAs as 400000.
<Sysname> system-view
101