Peer; Preference - HP FlexNetwork 3600 v2 Series Command Reference Manual

count: Maximum number of RIP packets sent at each interval. It is in the range of 1 to 20.
Description
Use output-delay to configure the maximum RIP packets that can be sent at the specified interval
for all interfaces under the RIP process.
Use undo output-delay to restore the default.
By default, an interface sends up to three RIP packets every 20 milliseconds.
Examples
# Configure all the interfaces under RIP process 1 to send up to 10 RIP packets every 30
milliseconds.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] output-delay 30 count 10

peer

Syntax
peer ip-address
undo peer ip-address
View
RIP view
Default level
2: System level
Parameters
ip-address: IP address of a RIP neighbor, in dotted decimal format.
Description
Use peer to specify the IP address of a neighbor in the non-broadcast multi-access (NBMA) network,
where routing updates destined for the peer are unicast, rather than multicast or broadcast.
Use undo peer to remove the IP address of a neighbor.
By default, no neighbor is specified.
You need not use the peer ip-address command when the neighbor is directly connected; otherwise
the neighbor may receive both the unicast and multicast (or broadcast) of the same routing
information.
Examples
# Specify to send unicast updates to peer 202.38.165.1.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] peer 202.38.165.1

preference

Syntax
preference [ route-policy route-policy-name ] value
undo preference [ route-policy ]
44