Comms Digital Input - ABB SM2000 User Manual

Advanced Videographic Recorder
SM2000

4.4.10 Comms Digital Input

Note. This tab is displayed only if 'Protocol' is set to 'Modbus Master' – see Section 4.4.8, page 61.
IM/SM2000 Issue 11
Select the comms digital input to hold the data from the
nominated slave device.
Enter the RTU address assigned to the remote unit (1 to 247).
Note. Displayed only if 'RTU Address'
Enter the register number to be read or written to in the slave
device.
Note. Displayed only if 'RTU Address'
Select the register type, 'Input Status' or 'Coil Status'.
4 CONFIGURATION
set to 'None'.
is not
set to 'None'.
is not
63