Scales - ABB SM2000 User Manual

Advanced Videographic Recorder
SM2000

4.6.6 Scales

Note.
Parameters applying only to Advanced configuration are identified
The scales configured here are used to scale analog channel data in the Chart View when 'Configuration type' is set to
'Advanced' – see Section 4.4.1, page 52. It has no effect on the Bargraph View (which always uses the engineering range
of the analog signal displayed – see Section 4.6.2, page 80) or on digital channels.
IM/SM2000 Issue 11
A
.
A
Set within the range -999 to 9999.
Set within the range -999 to 9999.
A
Set within the range -999 to 9999.
A
Typically set to a lower value than 'Primary range low'. When
selected in the Chart view (see Section 2.3, page 7), enables the
Operator to zoom in on data displayed.
Set within the range -999 to 9999.
A
Typically set to a lower value than 'Primary range high'. When
selected in the Chart view (see Section 2.3, page 7), enables the
Operator to zoom in on data displayed.
Select a signal source to enable switching between the
A
channel's primary and secondary scales. Refer to Appendix A,
page 108 for a description of the available sources.
Note. This signal is edge-triggered. A rising edge (inactive to
active) switches to the secondary scale. A falling edge (active to
inactive) switches to the primary scale.
Secondary
4 CONFIGURATION
Primary
93