Table of Contents
Advertisement
IMPORTANT:
and results do not improve, reset the substrate calibration value to its default setting of 30 (see below).
1.
Turn on the cutter and load the substrate with the calibration plot.
2.
Press
3.
Press
4.
Press
5.
Press
the screen.
The cutter allows you to choose whether to measure the substrate or fill in a previously recorded value.
Press
NOTE:
press
measure it again. Press
6.
Press
7.
Use
× 3 cm (1.2 × 1.2 in).
8.
Press
9.
Use
middle and slightly to the bottom right.
10.
Press
color. It briefly displays the measured values and then shows a value that is characteristic for this substrate
color and marker color combination. Store this value for future reference.
NOTE:
Make sure the test has been performed correctly. If OPOS cannot sense the markers, one of the manual
alignment methods must be used.
TIP:
Remember to reset the calibration before printing on a standard substrate.
Adjust cutting parameters
Some parameters should be reset whenever a new substrate is loaded.
Set knife depth and pressure
1.
Ensure that substrate is loaded in the cutter.
18
Chapter 3 Load the substrate
In most cases, substrate calibration is not recommended for OPOS. If you perform the calibration
.
. System setup appears on the screen. Press
or
until Calibrations appears on the screen, then press
or
to scroll through the menu until you reach Cal media. Press
when finished.
If a combination of substrate color and marker color has already been calibrated and recorded,
and then
. Now use
to confirm.
again. The cutter lowers the sensor. Put the sensor on the white area appears on the screen.
,
,
, and
to confirm.
,
,
, and
to confirm. The cutter makes a circular movement while it measures the reflection of the marker
An error message may appear if the sensor cannot differentiate between black, grey, and white.
, and
to enter this value directly, without having to
to maneuver the knife on top of a white area, which should be at least 3
to maneuver the knife on top of a black area, approximately in the
.
to confirm.
. Measure appears on
ENWW
Hide quick links:
Advertisement
Table of Contents
