Change The Origin; Extended Load - HP 54 Basic Cutter User Manual

NOTE: Although the OPOS sensor has been calibrated in the factory, HP recommends doing a test to determine
how well the factory-set parameters work with the materials you are using. If the accuracy is not satisfactory,
then do the OPOS calibration.

Change the origin

●
Press
The substrate moves to the new origin, and values appear on the screen. The X value is the distance from
the original origin; the Y value is the maximum cutting width.
● Press
Press
●
The X and/or Y value toggles.
● Press
The cutter comes online and is ready to receive data from the computer.
●
Or press
The cutter moves to its original origin and comes online.

Extended load

The extended load function makes it possible to define the limits of the Y axis so that the cutter can cut outside
the pinch rollers. Substrate has to be loaded before this function can be used.
1.
Press
2.
Press
3.
Press
4.
Press
5.
Press
6.
Press
7.
Press
8.
Press
NOTE: Tracking is not guaranteed when using this mode.
ENWW
, , , or
to toggle the Y value between the maximum cutting width and distance from the original origin.
to toggle between the maximum cutting length and the distance from the original origin.
if you have reached the desired origin.
to cancel.
.
. System setup appears on the screen. Press
> Actions. Press .
or to scroll through the menu until you reach Extended load.
or to define the new limit at the right (origin). The head moves to its new origin.
. Size appears on the screen.
or to define the new limit at the left.
.
to change the origin.
.
Change the origin 27