HP 54 Basic Cutter User Manual page 35

9. Check that the result is satisfactory. If not, change one of the above parameters. Reducing the velocity can
improve the result. You are recommended never to use cutting speeds greater than 400 mm/s (16 ips) with
cutting pressures above 170 g.
NOTE:
pieces can be taken out easily) and not cutting too deep (ensuring that the substrate keeps its strength
while cutting). Sometimes this balance does not exist, meaning that this substrate cannot be cut through
with satisfactory results.
NOTE:
TIP: When cutting through, parallel lines are recommended to be at least 1 cm away from each other.
Otherwise, while cutting the second line, the first line may come loose and cause trouble.
10.
Press
11.
Press
12.
Press
13.
Press
14.
Press
TIP: Recommended settings are: Panels: On; Panel size: 3–10 cm; Recut: Off; Sorting: On.
15. Press
16.
Press
ENWW
It is not always easy to find the correct balance between cutting deep enough (ensuring that the
FlexCut parameters are always metric, regardless of the value of the Units parameter.
to confirm.
to leave the FlexCut menu.
or to scroll through the menu until you reach Panels. Press
or to choose the panel parameter to be changed.
or to change the value of the chosen parameter.
to confirm. An asterisk appears by the value, indicating that it is now selected.
twice.
.
Detailed OPOS operations 31