Set The Tool Type - HP 54 Basic Cutter User Manual

HP Latex Cutter Extended Kit
This kit contains the following items:
Sandblast blades and holder
●
Sandblast blades are used for some very specific applications such as gravestones. These blades need a
special blade holder.
Pouncing kit, pin, and strip
●
The pouncing pin can be used if you prefer to pierce the substrate instead of cutting it. It comes together
with a pouncing kit and a cutting strip.
Black pen and pen holders
●
The pen can be used if you want to use the contour cutter as a drawing device. It comes with two pen
holders.

Set the tool type

The cutter is supplied with a knife, and alternative tools are available as accessories. All tools have one
parameter in common: the pressure. Other parameters are specific to the tool. Tool parameters can be changed
by changing them for the current user, or by changing the user.
NOTICE: The cutter will perform as specified only if a genuine HP tool is installed. Do not replace the standard
knife with products from other manufacturers.
1. Turn on the cutter.
2.
Press
3.
Press
4.
Press
5. Press
6.
Press
50 Chapter 8 Accessories
.
or until you reach Tool. Press
or to change the tool.
to confirm. An asterisk appears by the name of the tool, indicating that it is now selected.
twice to leave the menu.
.
ENWW