Performance - HP 54 Basic Cutter User Manual

Maximum working length
Front and rear margins
Side margins
Margin between prints (no cut-off)
Margin to cut off
Tracking performance
Thickness
NOTE: Tracking performance is not guaranteed in oversized mode.

Performance

This performance is achieved with wax-backed vinyl 0.05 mm (0.002 in) thick, total thickness not more than 0.25
mm (0.01 in).
Cut type
Cut width
Cut speed
Acceleration
Accuracy
Repeatability
Cut force
Cut thickness
NOTE: The repeatability and accuracy specifications are valid within the guaranteed tracking length (see
previous table), but not in oversized mode.
52 Chapter 9 Specifications
HP 54 Basic Cutter
HP Latex 54 and 64 Cutters
50 m (164 ft)
30 mm (1.2 in)
25 mm (1.0 in)
30 mm (1.2 in)
30 mm (1.2 in)
HP 54 Basic Cutter, HP Latex 54 and 64 Cutters
Up to 8 m (26 ft) within guaranteed specifications for substrates less than 762 mm (30 in) wide
Up to 4 m (13 ft) within guaranteed specifications for substrates more than 762 mm (30 in) wide
Longer substrates can be handled, but then compliance with specifications is not guaranteed
0.05 to 0.25 mm (0.002 to 0.01 in) with standard knife
Up to 0.8 mm (0.03 in) with optional sandblast knife
Drag-knife with TurboCut and Tangential emulation modes
135 cm (53.1 in) for the HP Latex 64 Cutter
158 cm (62.2 in) for the HP Latex 54 Cutter
Up to 113 cm/s (44 in/s) diagonal
Up to 84 cm/s (33 in/s) for substrates wider than 736 mm (29 in)
Up to 3 G diagonal
Up to 0.9 G for substrates wider than 736 mm (29 in)
0.2% of movement or 0.25 mm (0.01 in), whichever is greater
±0.1 mm (0.004 in)
0 to 400 g of downforce, in 5 g steps
0.05 to 0.25 mm (0.002 to 0.01 in)
0.8 mm (0.03 in) with optional sandblast blade
ENWW