HP 54 Basic Cutter User Manual page 26

Change parameter values for a user
1. Turn on the cutter.
2.
Press
3.
Press
4.
Press
5.
Press
6.
Press
7.
Press
8.
Press
9.
Press
NOTE: Velocity is the main speed parameter. The default value for the three other parameters is AUTO. This
means that they are linked to velocity (which is the speed when the tool is down). The AUTO parameters can be
set individually, but will then cease to be linked to the velocity parameter.
22 Chapter 3 Load the substrate
.
. System setup appears on the screen. Press
or to scroll through the menu until you reach Configuration. Press
or to scroll through the menu until you reach User. Press
again. The currently selected user name appears on the screen.
or to change the user.
to confirm. An asterisk appears by the user name, indicating that it is now selected.
twice to leave the menu.
.
.
.
ENWW