Wall Mounting - Panasonic KX-UDS124 Installation Manual

3.3 Wall Mounting

Mounting
WARNING
•
Make sure that the wall that the CS will be attached to is strong enough to support the CS
(approx. 330 g [11.6 oz]). If not, it is necessary for the wall to be reinforced.
•
Only use the wall-mounting equipment (screws, washers, wall mounting plate) included with
the CS.
•
When the CS is no longer in use, make sure to detach it from the wall.
CAUTION
•
When driving the screws into the wall, be careful to avoid touching any metal laths, wire laths or metal
plates in the wall.
•
Do not stretch or bend the cables. Also, do not allow anything to rest on the cables.
•
Use cables that are fire-resistant or fireproof.
•
The CS and the cables should never be placed near or over a radiator or other heat source.
•
Do not bundle cables that are connected to the CS with the AC power cords of machines located
nearby.
•
Make sure the cables are securely fastened to the wall.
1.
Place the reference for wall mounting on the wall to mark the 2 screw positions.
2.
Install the 2 screws and washers (included) into the wall.
Note
•
Make sure that the screw heads are at the same distance from the wall.
•
Install the screws perpendicular to the wall.
3.
Insert the upper and lower tabs of the wall mounting plate into the designated openings in the base unit.
Wall Mounting Plate
(PSKL1032Y4)
Tabs
4.
Slide the wall mounting plate in the direction of the arrow until it clicks.
3 Installing the SIP Cell Stations
Installation Guide 19