Panasonic KX-UDS124 Installation Manual page 35

3.
Once SIP-CS(1) turns on, release the RESET switch, and then press the RESET switch again.
SIP-CS(1) will enter Site Survey Master mode.
4.
Turn on SIP-CS(2) normally. SIP-CS(2) will enter Site Survey Slave mode automatically when it receives
a signal from SIP-CS(1).
5.
Place SIP-CS(1) where the Air Sync Master CS is planned to be located.
LED:
Red and green alternate flashing
6.
Place SIP-CS(2) in the location planned for the SIP-CS closest to the Air Sync Master CS (currently
SIP-CS[1]).
7.
Confirm whether the LED of SIP-CS(2) is green.
If it is not green, move SIP-CS(2) around to find a location where its LED turns green.
Note
•
The LED indicates radio signal strength levels for air synchronisation. For details, refer to "CS
Coverage Area for Establishing Conversations" in "4.2 Site Planning".
SIP-CS(1)
AC
(Site Survey
adaptor
Master Mode)
Planned Location for
Air Sync Master CS
LED:
Red flashing
SIP-CS(2)
(Site Survey
Slave Mode)
AC
adaptor
SIP-CS(1)
AC
adaptor
4 Deployment Procedure
Planned Location:
Installation Guide 35