Panasonic KX-UDS124 Installation Manual page 38

4 Deployment Procedure
Site Survey for S-PS Service Area
Each S-PS has a CS Area Check mode that monitors the state of the radio link to the SIP-CS to check the
S-PS service area for establishing conversations. In CS Area Check mode, the following are displayed on the
S-PS with a refresh interval of 2 seconds: the SIP-CS ID of the SIP-CS to which the S-PS is connected, the
radio strength level, and the Error Rate. For each confirmed SIP-CS location, set the S-PS to CS Area Check
mode, and then place a SIP-CS at that location to measure the coverage area. Then, record the results on the
map of the installation site. This site survey requires 1 S-PS and 1 SIP-CS.
Notice
Conduct the site survey starting with the confirmed location for Air Sync Master CS, and then go to closest
location next.
Before Site Survey for S-PS Service Area
Checking the SIP-CS ID Number
Check the SIP-CS ID number label attached to the SIP-CS.
The SIP-CS ID number is attached to the rear side of the SIP-CS.
Starting the S-PS in Maintenance Mode
The S-PS must be in Maintenance mode to conduct a site survey.
To enter Maintenance mode, follow the procedure below:
Note
Before using an S-PS, the battery must be inserted and then charged for the specified amount of time. For
details, refer to the documentation for the S-PS.
1.
The S-PS should be in a powered off state. If the S-PS is turned on, turn it off by pressing and holding the
POWER/CANCEL key.
2.
Turn on the S-PS by pressing and holding the POWER/CANCEL key.
3.
After turning on the S-PS, a blank screen will be displayed. At this time, press and hold the TALK/
SP-PHONE key for about 7 seconds, and then release the key.
The S-PS will start in Maintenance mode.
Maintenace Mode
Ver.01.00
Note
When it takes more than 7 seconds to start Maintenance mode, follow the procedure below to return
stand by screen:
a.
Press the left soft key.
Press [8] ® [1].
b.
The Maintenance mode main menu will be displayed.
4.
Press .
OK
38 Installation Guide