Ps Area Check - Panasonic KX-UDS124 Installation Manual

4.8 PS Area Check

In this section, you can check the service area, handover and voice quality using 2 registered S-PSs under
actual conditions.
Entering S-PS Area Check mode
1.
Start the S-PS in Maintenance mode.
For details, see "Starting the S-PS in Maintenance Mode" in "4.3 Site Survey".
2.
Select "PS area check".
3.
Press .
OK
4.
Repeat the procedure from 1 to 3 for another S-PS.
Note
Both S-PSs must be in PS Area check mode.
Conducting S-PS Area Check
1.
Call S-PS(2) from S-PS(1).
S-PS(1) sends a tone signal to S-PS(2), and S-PS(2) returns the signal back to S-PS(1).
You can hear a tone when this signal is received.
2.
Set S-PS(2) close to the SIP-CS and move around the service area listening to the tone from S-PS(1)'s
receiver to confirm voice quality and handover operation.
The CS-ID and signal strength of the SIP-CS you are connected to and the target SIP-CS for Handover is
displayed on the S-PS. When the signal strength is sufficiently strong, the CS-ID is displayed in green.
CS001-10
012 -09 009 -08
006 -68
017 -06 008 -05
014 -05 004 -04
Notice
When checking the PS area, ensure that at least one SIP-CS is displayed in green on the LCD of the
handset within the service area.
CSnnn-xx
nnn : Current sync CS ID
02%
xx : RSSI level
yy : Error rate
Detected CS IDs and RSSI level are displayed.
If the RSSI level exceeds the threshold,
it is displayed with green shading.
yy%
4 Deployment Procedure
Installation Guide 51