HP FlexNetwork 10500 Series Security Configuration Manual page 117
Hide thumbs
Also See for FlexNetwork 10500 Series:
- Configuration manual (512 pages) ,
- Specifications (42 pages) ,
- Datasheet (20 pages)
Table of Contents
Advertisement
Figure 37 Network diagram
Configuration procedure
1.
Configure the 802.1X client. Make sure the 802.1X client can update its IP address after the
access port is assigned to the guest VLAN or an authorization VLAN. (Details not shown.)
2.
Configure the RADIUS server to provide authentication, authorization, and accounting services.
Configure user accounts and authorization VLAN (VLAN 5 in this example) for the users.
(Details not shown.)
3.
Create VLANs, and assign ports to the VLANs on the access device.
<Device> system-view
[Device] vlan 1
[Device-vlan1] port gigabitethernet 1/0/2
[Device-vlan1] quit
[Device] vlan 10
[Device-vlan10] port gigabitethernet 1/0/1
[Device-vlan10] quit
[Device] vlan 2
[Device-vlan2] port gigabitethernet 1/0/4
[Device-vlan2] quit
[Device] vlan 5
[Device-vlan5] port gigabitethernet 1/0/3
[Device-vlan5] quit
4.
Configure a RADIUS scheme on the access device:
# Create RADIUS scheme 2000 and enter RADIUS scheme view.
[Device] radius scheme 2000
# Specify the server at 10.11.1.1 as the primary authentication server, and set the
authentication port to 1812.
103
Advertisement
Table of Contents
Troubleshooting
