HP FlexNetwork 10500 Series Security Configuration Manual page 46

Step
3. Enable accounting-on.
Configuring the IP addresses of the security policy servers
The NAS verifies the validity of received control packets and accepts only control packets from
known servers. To use a security policy server that is independent of the AAA servers, configure the
IP address of the security policy server on the NAS.
The security policy server is the management and control center of the EAD solution. To implement
all EAD functions, configure both the IP address of the security policy server and that of the IMC
Platform on the NAS.
To configure the IP address of a security policy server for a scheme:
Step
1. Enter system view.
2. Enter RADIUS scheme
view.
3. Specify a security policy
server.
Configuring the Login-Service attribute check method for SSH, FTP, and terminal users
The device supports the following check methods for the Login-Service attribute (RADIUS attribute
15) of SSH, FTP, and terminal users:
•
Strict—Matches Login-Service attribute values 50, 51, and 52 for SSH, FTP, and terminal
services, respectively.
•
Loose—Matches the standard Login-Service attribute value 0 for SSH, FTP, and terminal
services.
An Access-Accept packet received for a user must contain the matching attribute value. Otherwise,
the user cannot log in to the device.
Use the loose check method only when the server does not issue Login-Service attribute values 50,
51, and 52 for SSH, FTP, and terminal users.
To configure the Login-Service attribute check method for SSH, FTP, and terminal users:
Step
1. Enter system view.
2. Enter RADIUS scheme view.
3. Configure the Login-Service
attribute check method for
SSH, FTP, and terminal
users.
Enabling SNMP notifications for RADIUS
When SNMP notifications are enabled for RADIUS, the SNMP agent supports the following
notifications generated by RADIUS:
Command
accounting-on enable [ interval
seconds | send send-times ] *
Command
system-view
radius scheme
radius-scheme-name
security-policy-server
{ ipv4-address | ipv6 ipv6-address }
[ vpn-instance
vpn-instance-name ]
Command
system-view
radius scheme
radius-scheme-name
attribute 15 check-mode { loose
| strict }
32
Remarks
By default, the accounting-on
feature is disabled.
Remarks
N/A
N/A
By default, no security policy
server is specified for a scheme.
You can specify up to eight security
policy servers for a RADIUS
scheme.
Remarks
N/A
N/A
The default check method is
strict.