HP FlexNetwork 10500 Series Security Configuration Manual page 76

d. Select HP(Comware) as the access device type.
e. Select the access device from the device list or manually add the device with the IP address
10.1.1.2.
f. Leave the default settings for other parameters and click OK.
The IP address of the access device specified here must be the same as the source IP address
of the RADIUS packets sent from the switch. The source IP address is chosen in the following
order on the switch:
IP address specified by the nas-ip command.
IP address specified by the radius nas-ip command.
IP address of the outbound interface (the default).
Figure 22 Adding the switch as an access device
# Add a service.
Click the Service tab, and select User Access Manager > Service Configuration from the
navigation tree. Then, click Add to configure a service as follows:
a. Add a service named Dot1x auth, and set the service suffix to bbb, the authentication
domain for the 802.1X user. With the service suffix configured, you must configure the
access device to send usernames that include domain names to the RADIUS server.
b. Select Deploy VLAN and set the ID of the VLAN to be assigned to 4.
c. Configure other parameters as needed.
d. Click OK.
62