Mitsubishi Electric MELSEC-Q QD75M User Manual page 164

5 DATA USED FOR POSITIONING CONTROL
Setting Value, setting range
Value set with peripheral device
Servo amplifier setting invalid (
MR- MR- MR-
H-BN H-BN4 J2-B
2: Set the parameter value and switch power off once (The parameter is transferred to servo amplifier from QD75), then switch it on
again to make that parameter setting valid.
: Invalid, : Valid)
Value set with PLC program
MR- MR- MR-
J2S-B J2-Jr J2M-B
0
H
Slight vibration
suppression
control setting
Motor-less operation
selection
Electromagnetic brake interlock
output timing setting
1: is used to set up the setting
value. (Hexadecimal)
0
H
Low pass filter selection
Adaptive vibration suppression
control selection
Adaptive vibration suppression
control sensitivity selection
1: is used to set up the setting
value. (Hexadecimal)
5 - 73
MELSEC-Q
Setting value buffer memory
address
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
0000 30124 30224 30224 30424
H
0000 30125 30225 30325 30425
H