Maintenance Mode; How To Enter Maintenance Mode; Method Of Entering End-User Accessible Maintenance Mode; Method Of Entering Maintenance Mode For Service Personnel - Brother ADS-2000 Service Manual

1. MAINTENANCE MODE

Maintenance mode is exclusively designed for checking and setting the machine using the
buttons on the control panel.
1.1

How to Enter Maintenance Mode

1.1.1 Method of entering end-user accessible maintenance mode

Basically, the maintenance mode functions should only be accessed by service personnel.
However, end users are allowed to use some of these functions under the guidance of service
personnel over the phone. End users can only use the functions shaded in the table on the
next page.
<Operating Procedure>
(1) Press and hold the [Scan to PC] and [Scan to USB] buttons simultaneously, and plug the
AC cord into the outlet. The Power LED and the Scan to USB LED light.
(2) Press the [Scan to PC] button. All LEDs go out and the machine enters function number
selection mode of the end-user accessible maintenance mode.

1.1.2 Method of entering maintenance mode for service personnel

<Operating Procedure>
(1) Press and hold the [Stop] and [Scan to USB] buttons simultaneously, and plug the AC
cord into the outlet. The Power LED and the Error LED light.
(2) Press the [Stop], [Scan to USB], [Scan to PC], and buttons in this order. The Scan to PC
LED and the Scan to USB LED lights.
(3) Press the [Scan to PC] button. The Scan to LED and the Scan to USB LED go out and
the machine enters function number selection mode of the maintenance mode for
service personnel.
5-1
Confidential