Brother ADS-2000 Service Manual page 74

(6) Remove the two taptite bind B M3x10 screws, and release the four hooks. Slide the panel
ASSY in the direction of the arrow and release the six tabs from the upper chute.
Upper chute
Tabs
Note:
• Be careful not to pull any harness.
(7) Open the upper chute from the panel ASSY.
(8) Disconnect the document detection sensor harness, the document scanning position
sensor harness, the double feeding sensor harness (Sent), and the panel PCB harness
from the panel PCB ASSY.
(9) Release the panel PCB harness from the securing fixture, then pull out the panel PCB
harness from the hole on the upper chute.
Panel PCB harness
Double feeding sensor harness (Sent)
Document detection
sensor harness
Panel PCB ASSY
Panel ASSY
HARNESS ROUTING: Refer to
Assembling Note:
• Make sure that there is no slack in the panel PCB harness when reconnecting it.
Taptite bind B M3x10
Fig. 3-18
Document
scanning position
sensor harness
Fig. 3-19
"2. Panel PCB
3-22
Tabs
Hooks
Panel ASSY
Hooks
Panel PCB harness
Hole
Upper chute
ASSY".
Confidential