Panel Assy - Brother ADS-2000 Service Manual

9.10 Panel ASSY

(1) Remove the taptite bind B M3x10 screw, then remove the earth harness (YW).
(2) Release the hook to disconnect the core of the second side CIS flat cable from the
machine, then release the second side CIS flat cable, the panel PCB harness, the earth
harness (GN), and the earth harness (YW) from the securing fixtures.
(3) Pull out the core from the second side CIS flat cable. Then pull out the second side CIS flat
cable and the earth harness (BK) from the hole on the machine.
Hole
Second side
CIS flat cable
Earth harness (BK)
HARNESS ROUTING: Refer to
(4) Turn over the machine and open the top cover. Push the cover release lever to open the
front cover.
Note:
• Be careful not to drop the main PCB shield frame and the USB earth plate as they
are not secured.
(5) Push the front cover in the direction of arrow 5a to remove the boss A, and in the direction
of arrow 5b to remove the boss B. Then remove the front cover from the machine.
Front cover
Second side
CIS flat cable
"1. Main PCB
Boss A
5b
Core
Hook
Fig. 3-16
ASSY".
5a
Boss B
Fig. 3-17
3-21
Taptite bind B M3x10
Earth harness (YW)
Earth harness (GN)
Panel PCB harness
Confidential