Brother ADS-2000 Service Manual page 77

(6) Remove the taptite cup S M3x6 screw, and lift the upper chute earth spring.
(7) Push the two hooks on the upper chute outward, and remove the cover open lever shaft
from the upper chute.
(8) Remove the upper chute earth spring from the upper chute.
(9) Remove the two taptite bind B M3x10 screws, and remove the double feeding sensor
holder from the upper chute.
(10) Release the double feeding sensor harness (Sent) from the securing fixture, and remove
the double feeding sensor (Sent) from the upper chute.
Cover open lever shaft
Taptite bind B M3x10
Hook
Upper chute
HARNESS ROUTING: Refer to
Assembling Note:
• Attach the upper chute earth spring and the cover release lever spring on the position
described in the illustration above.
• Attach the upper chute earth spring under the cover open lever shaft.
Taptite cup S M3x6
Fig. 3-22
"2. Panel PCB ASSY".
3-25
Upper chute
earth spring
Cover release lever spring
Double feeding sensor holder
Double feeding sensor (Sent)
Double feeding
sensor harness (Sent)
Taptite bind B M3x10
Hook
Confidential