Table of Contents
Advertisement
P
ROGRAMMABLE
2, 4
DISPLAY
Press <DISPLAY> + an autodial key to display the function of
that key (for example, how it is programmed).
(Display)
HSET
Activate headset mode by pressing an autodial key.
Headset
mode key
HLD1–HLD
Press to place a call on hold and provide a display of the held call.
2, 3
8
You can hold one call at each <HLD> key. The held call does not
occupy a CAP.
(Hold loops)
Up to eight hold loop keys can be assigned.
2, 3
INC
Distinguishes incoming calls from outside the facility. When an
outside call rings at your console, the <INC> key and the <ANS>
(Incoming)
keys both ring. Press either key to answer.
2, 3
INF
Distinguishes calls from inside the facility. When an inside call
rings at your console, the <INF> key and the <ANS> keys both
(Information
ring. Press either key to answer.
)
1, 4
ICOM
Press <ICOM>, and dial a station number; the call terminates with
priority ringing (four quick rings).
(Intercom/Pri
ority)
1, 4
LNR
Press <LNR> to redial the most recently dialed number. (Also see
saved number redial.)
(Last number
redial)
Note:
2, 3
LOA
Lights when a station has been in use for an unusually long time.
Press to display the locked out station number. Check to determine
(Line lockout
if the station is in use. If the station is not in use, it should be made
alarm)
idle.
5-6
F
EATURES FOR
Table 5-3 SelecSet 940A Features(continued)
LNR does not store numbers dialed through system
speed dialing. It does not store internal numbers dialed
via autodial keys; it does store external numbers dialed
via autodial keys.
S
S
K
ELEC
ET
EYS
HCXTD860, Rev. A01, September 2001
S
S
940A U
ELEC
ET
G
SER
UIDE
Advertisement
Table of Contents
